decrements a packet's Hop Limit to zero, it MUST discard the packet
   and send an ICMPv6 Time Exceeded message with Code 0 to the source of
   the packet.  This indicates either a routing loop or too small an
   initial Hop Limit value.

   The router sending an ICMPv6 Time Exceeded message with Code 0 SHOULD
   consider the receiving interface of the packet as the interface on
   which the packet forwarding failed in following rule (d) for
   selecting the Source Address of the message.

   Upper layer notification

   An incoming Time Exceeded message MUST be passed to the upper-layer
   protocol.




 
RFC 1885                 ICMPv6 (ICMP for IPv6)            December 1995


3.4 Parameter Problem Message

       0                   1                   2                   3
       0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      |     Type      |     Code      |          Checksum             |
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      |                            Pointer                            |
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      |                    As much of invoking packet                 |
      +               as will fit without the ICMPv6 packet           +
      |                       exceeding 576 octets                    |

   IPv6 Fields:

   Destination Address

                  Copied from the Source Address field of the invoking
                  packet.

   ICMPv6 Fields:

   Type           4

   Code           0 - erroneous header field encountered

                  1 - unrecognized Next Header type encountered

                  2 - unrecognized IPv6 option encountered

   Pointer        Identifies the octet offset within the
                  invoking packet where the error was detected.

                  The pointer will point beyond the end of the ICMPv6
                  packet if the field in error is beyond what can fit
                  in the 576-byte limit of an ICMPv6 error message.

   Description

   If an IPv6 node processing a packet finds a problem with a field in
   the IPv6 header or extension headers such that it cannot complete
   processing the packet, it MUST discard the packet and SHOULD send an
   ICMPv6 Parameter Problem message to the packet's source, indicating
   the type and location of the problem.

   The pointer identifies the octet of the original packet's header
   where the error was detected. For example, an ICMPv6 message with
   Type field = 4, Code field = 1, and Pointer field = 40 would indicate




 
RFC 1885                 ICMPv6 (ICMP for IPv6)            December 1995


   that the IPv6 extension header following the IPv6 header of the
   original packet holds an unrecognized Next Header field value.

   Upper layer notification

   A node receiving this ICMPv6 message MUST notify the upper-layer
   protocol.