RFC 1945                        HTTP/1.0                        May 1996


       Full-Response   = Status-Line             ; Section 6.1
                         *( General-Header       ; Section 4.3
                          | Response-Header      ; Section 6.2
                          | Entity-Header )      ; Section 7.1
                         CRLF
                         [ Entity-Body ]         ; Section 7.2

   A Simple-Response should only be sent in response to an HTTP/0.9
   Simple-Request or if the server only supports the more limited
   HTTP/0.9 protocol. If a client sends an HTTP/1.0 Full-Request and
   receives a response that does not begin with a Status-Line, it should
   assume that the response is a Simple-Response and parse it
   accordingly. Note that the Simple-Response consists only of the
   entity body and is terminated by the server closing the connection.

6.1  Status-Line

   The first line of a Full-Response message is the Status-Line,
   consisting of the protocol version followed by a numeric status code
   and its associated textual phrase, with each element separated by SP
   characters. No CR or LF is allowed except in the final CRLF sequence.

       Status-Line = HTTP-Version SP Status-Code SP Reason-Phrase CRLF

   Since a status line always begins with the protocol version and
   status code

       "HTTP/" 1*DIGIT "." 1*DIGIT SP 3DIGIT SP

   (e.g., "HTTP/1.0 200 "), the presence of that expression is
   sufficient to differentiate a Full-Response from a Simple-Response.
   Although the Simple-Response format may allow such an expression to
   occur at the beginning of an entity body, and thus cause a
   misinterpretation of the message if it was given in response to a
   Full-Request, most HTTP/0.9 servers are limited to responses of type
   "text/html" and therefore would never generate such a response.

6.1.1 Status Code and Reason Phrase

   The Status-Code element is a 3-digit integer result code of the
   attempt to understand and satisfy the request. The Reason-Phrase is
   intended to give a short textual description of the Status-Code. The
   Status-Code is intended for use by automata and the Reason-Phrase is
   intended for the human user. The client is not required to examine or
   display the Reason-Phrase.







 
RFC 1945                        HTTP/1.0                        May 1996


   The first digit of the Status-Code defines the class of response. The
   last two digits do not have any categorization role. There are 5
   values for the first digit:

      o 1xx: Informational - Not used, but reserved for future use

      o 2xx: Success - The action was successfully received,
             understood, and accepted.

      o 3xx: Redirection - Further action must be taken in order to
             complete the request

      o 4xx: Client Error - The request contains bad syntax or cannot
             be fulfilled

      o 5xx: Server Error - The server failed to fulfill an apparently
             valid request

   The individual values of the numeric status codes defined for
   HTTP/1.0, and an example set of corresponding Reason-Phrase's, are
   presented below. The reason phrases listed here are only recommended
   -- they may be replaced by local equivalents without affecting the
   protocol. These codes are fully defined in Section 9.

       Status-Code    = "200"   ; OK
                      | "201"   ; Created
                      | "202"   ; Accepted
                      | "204"   ; No Content
                      | "301"   ; Moved Permanently
                      | "302"   ; Moved Temporarily
                      | "304"   ; Not Modified
                      | "400"   ; Bad Request
                      | "401"   ; Unauthorized
                      | "403"   ; Forbidden
                      | "404"   ; Not Found
                      | "500"   ; Internal Server Error
                      | "501"   ; Not Implemented
                      | "502"   ; Bad Gateway