GLOSSARY ......................................................... 64

   REFERENCES ....................................................... 67
 
 


Network Working Group                                          J. Postel
Request for Comments: DRAFT                                          ISI
Replaces: RFC 788, 780, 772                                  August 1982

                     SIMPLE MAIL TRANSFER PROTOCOL


1.  INTRODUCTION

   The objective of Simple Mail Transfer Protocol (SMTP) is to transfer
   mail reliably and efficiently.

   SMTP is independent of the particular transmission subsystem and
   requires only a reliable ordered data stream channel.  Appendices A,
   B, C, and D describe the use of SMTP with various transport services.
   A Glossary provides the definitions of terms as used in this
   document.

   An important feature of SMTP is its capability to relay mail across
   transport service environments.  A transport service provides an
   interprocess communication environment (IPCE).  An IPCE may cover one
   network, several networks, or a subset of a network.  It is important
   to realize that transport systems (or IPCEs) are not one-to-one with
   networks.  A process can communicate directly with another process
   through any mutually known IPCE.  Mail is an application or use of
   interprocess communication.  Mail can be communicated between
   processes in different IPCEs by relaying through a process connected
   to two (or more) IPCEs.  More specifically, mail can be relayed
   between hosts on different transport systems by a host on both
   transport systems.

























 

                                                                        
August 1982                                                      RFC 821
Simple Mail Transfer Protocol                                           



2.  THE SMTP MODEL

   The SMTP design is based on the following model of communication:  as
   the result of a user mail request, the sender-SMTP establishes a
   two-way transmission channel to a receiver-SMTP.  The receiver-SMTP
   may be either the ultimate destination or an intermediate.  SMTP
   commands are generated by the sender-SMTP and sent to the
   receiver-SMTP.  SMTP replies are sent from the receiver-SMTP to the
   sender-SMTP in response to the commands.

   Once the transmission channel is established, the SMTP-sender sends a
   MAIL command indicating the sender of the mail.  If the SMTP-receiver
   can accept mail it responds with an OK reply.  The SMTP-sender then
   sends a RCPT command identifying a recipient of the mail.  If the
   SMTP-receiver can accept mail for that recipient it responds with an
   OK reply; if not, it responds with a reply rejecting that recipient
   (but not the whole mail transaction).  The SMTP-sender and
   SMTP-receiver may negotiate several recipients.  When the recipients
   have been negotiated the SMTP-sender sends the mail data, terminating
   with a special sequence.  If the SMTP-receiver successfully processes
   the mail data it responds with an OK reply.  The dialog is purposely
   lock-step, one-at-a-time.

     -------------------------------------------------------------

   
               +----------+                +----------+
   +------+    |          |                |          |
   | User |<-->|          |      SMTP      |          |